All About Auto

When draining the Nissan Navara brake fluid, refill with a new brake fluid “DOT 3”. Never reuse the brake fluid drained from the unit. Brake fluid can cause damage on your car paint, therefore avoid the brake fluid to splash on the car painted areas. If splashing of brake fluid are cannot be avoided, immediately wipe off the affected area and rinse with water.

When working with your Nissan Navara model, it is advisable to disconnect the connector of ABS actuator and electric unit or the battery negative terminal before you start any of the repair work.

When doing the brake bleeding, pay attention to master cylinder fluid level,
For LH Drive Navara

1. Connect a vinyl tube to the load sensing valve.
2. Fully depress brake pedal 4 to 5 times.
3. With brake pedal depressed, loosen bleed valve to let the air out, and then tighten it immediately.
4. Repeat steps 3, 4 until there is no more air comes out.
5. Tighten bleed valve.
6. From the steps 1 to 5 above, with master cylinder reservoir tank filled at least half way, bleed air from the rear left, front right, rear right, and front left brake, in that order

For RH Drive Navara

Follow step 1 to 5 specified for the LH drive Navara except that from the steps 1 to 5 above, with master cylinder reservoir tank filled at least half way, bleed air from the rear right, front left, rear left, front right brake, in that order.

When doing your routine maintenance always makes sure that your Nissan Navara brake fluid level are between “MAX” and “MIN” lines on the reservoir.

Tags : nissan, automotive, Navara