Nissan Navara Engine Oil Low Light Resetting | its all about car

Search cartechhome.com

Welcome to cartechhome.com its all about car. Your guide for troubleshooting common car problems on transmission, engine, car air-con, brakes, and car electrical for easy car repair.

Nissan Navara Engine Oil Low Light Resetting

Nissan Navara oil low light resetting equipped on the D40 is the engine oil level and oil change schedule indicator, it is located on the instrument panel of the vehicle.  A wrench symbol appears on the instrument panel to remind the driver that the vehicle is due for maintenance.


This feature will then be notice when the ignition switch is turned on, The wrench symbol including the distance to which the oil change is necessary will appear on the instrument panel for an approximately 5 seconds. After that the oil level information will be displayed.

Oil Good is displayed when the vehicle engine oil is sufficient for driving.
Oil Lo is displayed when the engine oil level is low and not sufficient for driving. If the oil lo refill the engine with necessary amount of oil.


cartechhome imageHow will you know the level of engine oil?

To determine the level of the engine oil, push the reset knob while the Oil Good message is displayed, the oil level will be displayed raging level 5 to level 1.

If the distance displayed for the oil change is exceeded, a negative sign will appear just before the displayed distance and the wrench symbol will blink continuously to draw the attention on the driver, in this case you it necessary to change the oil.

How to adjust the change oil interval?

You can also adjust the oil interval, just press the trip odometer / trip reset knob for more than 3 seconds while the wrench symbol and distance are displayed. It will start flashing and the current interval will show.

cartechhome image
Press the reset knob again to increase the interval distance of oil change. Interval distance can be increase by 500km by default. The maximum interval distance shown for oil change is 30,000 km and the minimum interval distance is 0. But if you choose the Zero interval distance, the change oil schedule function will be disabled and a wrench symbol and distance will not be shown every time the ignition is turned on.

How to activate oil change schedule?

To activate the oil change schedule function, press the odometer/trip computer reset knob for about 3 seconds, within the 5 seconds period after the ignition was turned on.

By default the the oil change interval schedule of Navara is set to 30,000km, you should adjust the oil change interval schedule based on warranty booklet provided by the Navara manufacturer.

Suggested Reading:
Nissan Navara D40 Change Oil
Change Oil Filter for D40 Navara

No comments:

Post a Comment

“ Please share this post to others so that it may also help them about their car problem.”