Navara D40 service intervals will never be neglected because there is a feature on Nissan Navara that reminds the driver of the service schedule.
One of the crucial maintenance that must not be neglected for your Nissan Navara D40 is the service schedule. But admit it no matter how we include it in our plan we sometimes forget about it, but for Navara owner, it makes some difference, Navara D40 has features that remind the driver of the service interval. Navara service indicator light is a feature that appears on the dashboard when it is time for the change oil. It was set base on the Nissan Navara D40 service intervals.
Nissan Navara D40 Maintenance Schedule
Note:
Maintenance items with "Star Mark" should be performed more frequently according to "Maintenance Under Severe Driving Conditions".
(1) Periodic maintenance is not required, However, if valve noise increases, check valve clearance.
(2) Replace the drive belts if found damaged or if the auto belt tensioner reading reaches the maximum limit.
(3) Use Genuine NISSAN Engine Coolant or equivalent in its quality, in order to avoid possible aluminum corrosion within the engine cooling system caused by the use of non-genuine engine coolant. After first replacement, replace every 40,000 km (24,000 miles) or 24 months.
How to change the engine oil of Nissan Navara D40
Step 1. Warm up the engine, drive the Navara on level ground, and check for oil leakage from engine components. When checking for the engine oil leakage, do the inspection around each part such as oil pan, oil pan drain plug, oil pressure switch, oil filter, oil cooler, intake valve timing control cover, and intake valve timing control solenoid valve, front cover, the mating surface between the cylinder block and lower cylinder block, the Mating surface between the cylinder block and head, the mating surface between cylinder head and rocker cover and crankshaft oil seals (front and rear).
Step 2. After the engine is warmed up, stop the engine and wait for 10 minutes before doing the change oil.
Step 3. Loosen the oil filler cap and place a catch basin for the engine oil, then remove the drain plug to drain the engine oil.
Nissan Navara D40 Oil Filter Location
Step 4. Install the drain plug, never re-use the washer of the drain plug instead replace it with a new washer. Make sure
Nissan Navara D40 Drain Plug LocationStep 5. Refill the engine with new engine oil. For Nissan Navara D40 with the YD25 engine & QR25 engine, the approximate refill amount of engine oil is described below. The refill capacity depends on the engine oil temperature and drains time. Use the below specifications for reference only.
Nissan Navara D40 Recommended OilStep 6. Warm up the engine again and check the area around the drain plug and oil filter for oil leakage.
Step 7. Stop the engine and wait for 10 minutes then check the engine oil level.
When doing change oil for your Nissan Navara D40, try to avoid direct contact with the used engine oil, repeated contact can cause skin problems. Change oil on your Navara D40 based on the recommended schedule can maximize the efficiency and life of the engine. Therefore always monitor the change in oil frequency.
Want more videos all about auto?
Subscribe to our YouTube channel! » Cartech Home
Share with us what you think about this topic to provide another reader more information that this article should have covered.